Water softening NL
Water hardness °dH
Hardness range
mmol/l
Set value
9 - 10
11 - 12
13 - 16
17 - 21
22 - 30
31 - 50
average
average
average
hard
hard
hard
1.5 - 1.8
1.9 - 2.1
2.2 - 2.9
3.0 - 3.7
3.8 - 5.4
5.5 - 8.9
H:02
H:03
H:04
H:05
H:06
H:07
Note Set the device to the
determined water hardness.
With a water hardness of 0 - 6 °dH you
do not need to use softening salt and
you can switch off the water softening.
master start at. The required amount
of softening salt depends on the
water hardness. The higher the water
hardness, the greater the amount of
softening salt required.
Set water softening
PAY ATTENTION!
s Dishwasher detergent can damage the water
damage hardening.
▶
The reservoir of the softener
Only fill the water supply with
special salt for dishwashers.
s The rinse aid container can be
corrode softening salt.
▶
To ensure that
spills softener salt from the
rinse aid container is rinsed, the
softener salt is filled into the
softener salt reservoir
immediately before the program
starts.
Set the appliance to the water
hardness.
1.
Determine the water hardness and
the desired setpoint.
2.
on
3.
to press.
press and hold
Pine tree.
display shows H:04.
6.
Turn the program selector until the
4.
Turn the program selector until the
5.
Release key.
desired position is set.
The factory setting is H:04.
1.
Open the lid of the softening salt
reservoir and remove it.
7.
on
press to save the setting.
2.
When using for the first time: fill the
reservoir completely with water.
Softening salt
3. Note Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
You can soften the water with
softening salt.
Filling softening salt
When the Refill softener salt
indicator lights up, fill the softener
salt into the softener salt reservoir
immediately before the program
Place the softening salt in the
softening salt reservoir.
29