1.3
Presentation of Information
1.3.1
Explanation of signal words and the Safety alert symbol
The Safety Instructions in the available application documentation contain
specific signal words (DANGER, WARNING, CAUTION or NOTICE) and,
where required, a safety alert symbol (in accordance with
ANSI Z535.6-2011).
The signal word is meant to draw the reader's attention to the safety instruc‐
tion and identifies the hazard severity.
The safety alert symbol (a triangle with an exclamation point), which pre‐
cedes the signal words DANGER, WARNING and CAUTION, is used to alert
the reader to personal injury hazards.
DANGER
In case of non-compliance with this safety instruction, death or serious injury
will occur.
WARNING
In case of non-compliance with this safety instruction, death or serious injury
could occur.
CAUTION
In case of non-compliance with this safety instruction, minor or moderate in‐
jury could occur.
NOTICE
In case of non-compliance with this safety instruction, property damage could
occur.
1.3.2
Symbols
Symbol
Significance
Reference to supplementary documentation
This note gives important information, which must be observed.
1.
2.
3.
Numbered action instructions:
The numbers show that the action steps must be taken one after the
other.
Warning against dangerous electric voltage
Warning against hot surfaces
Warning against rotating machine parts
Bosch Rexroth AG
DOK-SYTROX-MPES2******-IT01-EN-P
Rexroth Sytronix FcP 50xx/70xx Motor-Pump Unit MPES2
16/143
About this Documentation
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
