REFUspeed RS51
Basic parameterization
7-1
DOK-RD500*-RS51*******-IB02-EN-P
7
Basic parameterization
7.1
Parameterizing
The REFU
drive 500
drives can be parameterized in two ways:
1.
Basic parameterization:
In this case, the operator has menu-
prompted, pre-defined functions to facilitate simple and fast commis-
sioning. The possibilities are numerous; for example, control and set-
point source can be configured, status messages, analog values can
be called and important basic functions can be parameterized. The
basic parameterization is selected when the equipment is shipped
(default setting). Only the basic parameterization is described in the
reminder of this Section.
2.
Free parameterization:
In this case, the complete functional scope
of the drive can be utilized. Logic gates, comparators, a technology
controller, several multi-function blocks and many more are available.
The free parameterization is described in the Manual “Function de-
scription: Firmware”.
Structure of the basic parameterization
The basic parameterization comprises three main menus:
Selected parameters for fast commissioning (motor adaption, ramp-
up/ramp-down time ....)
The drive is adapted, menu-prompted to the particular application
Adaption possibilities can be directly selected
The main menu of the basic parameterization is displayed by pressing the
Prog
key. The main-menu is sub-divided into additional levels. The fol-
lowing diagram shows the structure of the various menu levels.
Quick setup:
Prompted parameterization:
Numerical list:
LSA Control S.L. www.lsa-control.com [email protected] (+34) 960 62 43 01
