236
Bosch Rexroth AG
| Tightening Technology
3 608 870 A47
Nexo cordless Wi-Fi nutrunner
| 3 608 870 A47/2019-
9.8.7
PLC signals
Settings
PLC signals
Use this menu item to create a PLC assignment table. The assignment table describes the assignment of
the PLC signals to inputs and outputs.
Table 9–83:
PLC signals tab
Element
Description
Inputs/outputs
The input signals are on the left side of the window and the output signals on
the right.
Control signals/status signals
The signal list shows all of the signals available.
– Already assigned and no longer available signals in the signal list will be
gray.
– Each input signal can only be assigned once. Each output signal can be
assigned up to a maximum of four times.
Inserts a signal highlighted in the signal list in the selected insert position of
the assignment table.
Removes the highlighted signal from the assignment list.
PLC signals from BMW-TPC - PLC module
BmwTpc
PLC signals from Rexroth Open Protocol - PLC module
oprtcl
PLC signals of the nutrunner - PLC module
tool
As of Nexo firmware version 1300. If the nutrunner is in manual mode, the
Prg0-Prg7
signals can no longer be applied.
PLC signals of VW-XML - PLC module
vwXml
Activate
Click
Activate
to activate the PLC signals of the module selected.
Deactivate
Click
Deactivate
to deactivate the PLC signals of the module selected.
Save
Click
Save
to save the edited data.
Discard
Click
Discard
to discard the edited data.
Restore defaults
All settings in this tab are reset to the factory setting.
BmwTpc
oprt
cl
vwXml
