3 608 870 A47
Tightening Technology |
Bosch Rexroth AG 207
Nexo cordless Wi-Fi nutrunner
| 3 608 870 A47/2019-10
9.7.4.3
End step
A tightening program ends with the end step.
The end step ends the tightening program and terminates each program column (A, B, etc.) in the run
sequence. The tightening program may have several end steps if it contains branches. The end step is
automatically inserted into the tightening program and cannot be deleted.
Table 9–47:
Tightening step dialog - monitoring panel
Element
Description
Torque, torque min. value, torque
max. value, angle, angle min. value,
angle max. value
These monitoring functions can also be selected.
Each of the monitoring limits can be marked as switching. If a limit is
switching, the tightening process will be stopped with an NOK result when it
exceeds or falls below its limit.
If it is not switching, the tightening process will be completed as usual,
however, the result will be NOK.
Time
This monitoring function is always active, i.e. a time span must be entered for
a timeout.
Double clicking the end step or the respective icon opens the corresponding dialog for
entering the name.
The entire tightening can only be evaluated as OK, if the same is terminated in column A. Otherwise, it
will be evaluated as NOK.
Table 9–48:
End step dialog – settings panel
Element
Description
Name
End step name
