Code I / Code II (EN 60034-7)
IM B5 / IM 3001
Flange attachment on the drive side of the
flange
IM V1 / IM 3011
Flange attachment on the drive side of the
flange, drive side facing down
IM V3 / IM 3031
Flange attachment on the drive side of the
flange, drive side facing up
Avoid liquid at the drive shaft or the shaft sealing ring in case of vertical in‐
stallation according to IM V3. For further information regarding the protection
class, see
chapter 4.2.8 "Degree of protection " on page 13
4.2.15
Coating
1K-standard varnish, water-based, RAL 9005 black
Danger of explosion due to improper change
of the surface characteristics.
WARNING
An additional varnish on motors for hazardous areas is not allowed in order
not to negatively influence the surface characteristics (like e.g. insulation re‐
sistance, electrostatic charging).
4.2.16
Noise emission
The typical sound pressure level Lp(A) is specified for the speed range 0 rpm
up to the rated speed, see
chapter 4.2.1 "Basic data" on page 9
. The instal‐
lation situation affects the noise emission.
MS2E Synchronous Servomotors acc. to ATEX Directive
2014/34/EU
23/65
About this product
R911387136_Edition 02 Bosch Rexroth AG
