Bosch rexroth MCL, Project Planning Manual

Page: 141 / 206

10 Motor-control combinations
10.1 General
The technical data and the figure of the motor characteristics of several mo‐
tors is displayed in chapter 4 "Technical data" on page 21 .
A dimensioning and selection of individual motors must be done
in Gantry arrangement.
Maximum allowed intermediate
circuit.
Frame size dependend maximum DC bus voltages for MCL motors are de‐
fined. Please also observe the information provided under tab. 4-1 "General
technical data" on page 27 .
Exceeding of voltage limits!
DANGER
Prepare a suitable connection with a protective switch via the primary part
carrier when using AC voltage > 50 V or DC > 120 V (DIN IEC 60364-4-41)
for MCP015.
10.2 Motor-control combinations with NYCe 4000
NYCe 4120 NYCe 4140
48 V 72 V 150 V
MCP015A-L040
MCP015B-L040
■ ■ -
MCP020x-Vxxx x x
MCP030x-Vxxx x x
MCP040x-Vxxx x x
MCP070x-Vxxx x x
■ optimum combination
x permitted combination - reduced velocity, as DC bus voltage is
reduced in relation to nominal voltage.
- Combination not permitted
Tab. 10-1: Motor-control combinations with NYCe 4000
MCL Ironless Linear Motors 133/197
Motor-control combinations
R911330592_Edition 06 Bosch Rexroth AG