7.3.5
Auxiliary function groups
Auxiliary function groups are required for representing the current auxiliary
functions on the HMI. The auxiliary function that was the last to be output is
shown of each defined group. The figure shows an example where functions
M3, S10 and T1 were the last to be output in their particular groups.
Fig. 7-8:
Displaying the auxiliary functions on the HMI
The MTX micro allows defining up to 64 auxiliary function groups and assign‐
ing up to 15 auxiliary functions to each of these groups. The basic projects
are configured as shown in the figure below. Groups 1–14 should not be
changed.
Fig. 7-9:
Default assignment of auxiliary function groups
If you wish to have the auxiliary functions M80 and M86 (and therefore the
previously programmed state of the swiveling device) displayed on the HMI,
enter these two functions in a common group.
Example 301001014 = S:, M80, M86
DOK-MTXMIC-EASY*******-CO06-EN-P
Bosch Rexroth AG
79/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
PLC commissioning
