Fig. 6-6:
Entering the IP communication data
1.
Select "System" on the HMI control panel, and use the cursor keys to
select "IP address"
2.
Activate the editing mode by clicking on <Enter>, enter
"192.168.142.250" in the input field and confirm with enter
3.
Select "Subnet mask", enter "255.255.255.0" in the input field and con‐
firm with enter
4.
Select "Gateway", enter "0.0.0.0" in the input field and confirm with enter
5.
Switch the MTX micro off and on again to apply the settings.
6.
After the system has been restarted, the configured IP address is dis‐
played in the "System" operating area.
6.3.4
Setting the IP address of the PC
The PC must have its IP address in the same network segment as the MTX
micro. To achieve this, a fixed address is set. The first 3 digits always corre‐
spond to the IP address of the MTX micro. The subnet mask is the same as
that of the MTX micro.
We recommend the following settings:
●
IP Address → 192.168.142.251
●
Subnet Mask → 255.255.255.0
●
Standard gateway → no entries
Bosch Rexroth AG
DOK-MTXMIC-EASY*******-CO06-EN-P
66/177
IndraMotion MTX micro Easy Setup for Standard Turning and Milling Machines
Software installation and basic projects
