Bosch Rexroth IndraMotion MTX 11 VRS, Applications Manual, Page: 89 / 304

– Direct approach
– Approaching via return program
● Point of return
–
At the point of interruption
– At the start of the interrupted block
– At the end of the interrupted block
A At the point of interruption
B Setting point
C Leaving position
D Block start
E Block end
Fig.6-12: Principle of leaving/returning to contour
Operating Steps
Processing has to be interrupted before leaving the contour!
Feed Stop Press the "Feed Stop" button on the machine panel.
Processing of the part program is interrupted. The position where the axes
stand still is called the point of interruption (1).
Adjustment Options Press the M-key <L8> "Program functions".
A new M-key level with the following functions appears on the left side:
●
Leaving and returning <L1>
● Block search <L2>
● Re-entry <L3>
● Block pre-run <L4>
● Retracing <L5>
● Back <L8>
Leaving the contour Press the M-key <L1> "Leaving and returning".
The operation mode "Leaving the contour" is displayed in the machine status
area
DOK-MTX***-NC*OP***V11-AP01-EN-P
Rexroth IndraMotion MTX 11VRS Standard NC Operation Bosch Rexroth AG 87/301
Operation Modes