NC Block Numbering
It is possible to predefine a starting block number. All NC blocks are renum‐
bered with the preselected increment.
NC blocks with conditional or unconditional jumps are not renumbered. The
original block numbers are retained in this case. They have to be adapted
manually.
CPL Block Numbering
It is possible to predefine a starting block number. All CPL blocks are renum‐
bered with the preselected increment.
NC Simulation
The NC simulation can be started if a corresponding license exists. Changes
to the NC program are saved first. The NC Editor remains open so that any
corrections can be carried out immediately after exiting the simulation. If the
simulation in the program is stopped and the Editor is retrieved again, the po‐
sition where the simulation was terminated in the NC program is immediately
marked.
Options
The following options are available and can be set:
●
Font and size
The font and font size can be set in a dialog box. These settings remain
in effect until they are changed.
●
Tabulator stops
Up to 10 tabulator stops can be defined. When the function is retrieved,
the entire program is highlighted, so that the specified tabulator can come
into effect for the entire program immediately. Then the mark is removed.
●
GNP options
See documentation Shop Floor Programming
(DOK-MTX***-SF*PROG*V09-AW0x-EN-P).
●
Simulation options
See documentation Shop Floor Programming
(DOK-MTX***-SF*PROG*V09-AW0x-EN-P).
●
Syntax highlighting
Here, one or more file extensions can be specified for which syntax high‐
lighting is used. The following extensions have been entered already: npg,
cpl, dat, txt and files with no extension. Others can be added; these can
also be removed again. By default, file extensions "npg" and "cpl" are
shown with syntax highlighting.
7.2.7
GNP Correction Function
This function is available only if you have a license for GNP.
It retrieves the correction of a GNP instruction. This command opens its own
dialog box which covers that of the NC Editor.
7.2.8
Text Editor
The text editor is retrieved for large programs (default >1 MB). The options for
the text editor can be set using the F-keys under "Tools/Options/Adjust". In
doing so, general text editor settings can be made or the editor can be activated
Application Description | Rexroth IndraMotion MTX 09VRS
Electric Drives
and Controls
| Bosch Rexroth AG
85/233
Programming
