Bosch Rexroth IndraDyn S MS2N, Operating Instructions Manual

Page: 43 / 118

H
1
2
3
1 Centering hole
2 Identification Auswuchtung
3 Keyway
Fig. 4-5: Shaft end
Attachment of drive elements
The mode of balancing of drive elements must be adjusted to the motor. Ob-
serve the notes about mounting drive elements.
Motor damage by intrusion of liquid!
CAUTION
Pending liquids (e.g. cooling lubricants, gearbox oil, etc.) at the drive shaft are
inadmissible.
When installing gearboxes please use gearboxes with closed (oil-proof) lubrica-
tion system only. Gearbox oil should not be in permanent contact with the shaft
sealing ring of the motors.
Gearbox mounting on motors
Observe the instructions in the corresponding manufacturer´s documentation.
Overdetermined bearing
When installing drive elements, avoid overdetermined bearing as impermissibly
high bearing reactions can be generated due to unfavorable tolerance ratios.
If overdetermined arrangement of bearings cannot be avoided,
please contact Bosch Rexroth.
Couplings
The machine construction and the drive elements used must be carefully adap-
ted to the motor type so as to make sure that the load limits of the shaft and the
bearing are not exceeded.
MS2N Synchronous Motors Bosch Rexroth AG
About this product
DOK-MOTOR*-MS2N*******-IT03-EN-P
21/95