Bosch Rexroth IndraDyn MAD100B Rexroth IndraDyn MAD100C, Project Planning Manual

Page: 187 / 276

8.4.3 Connection diagram
(+)
(-)
8
7
6
5
X5
X6
A1
+24VBr
A2
A3
0VBr
MotTemp-
M
3
1
2
3
GNYE
U
V
W
PTC
1
U
3
4
5
6
1
2
1TP2 (-)
1TP1 (+)
BD (-)
BD (+)
3
4
2
3
4
5
6
1
2
PTC
① Holding brake (option)
② Spare temperature sensor (connect spare sensor lines only if
necessary)
③ Shield connection by clamping the cables of the strain relief in
the cable gland
④ Connection designations on the Rexroth drive controller
Fig. 8-3: Terminal box connection diagram
● Brake connections 1-2 are only assigned if the motor is man‐
ufactured with the optional brake.
● Only one contact pair of PTC thermistor connections 3-4 and
5-6 is connected to the motor cable.
● The seal which is glued into the lid at the factory may not de‐
tached or damaged.
● Observe the size of the cable gland and connection thread
for the cable inlet into the terminal box.
● Make particularly sure that the connecting cables are placed
orderly and without strain in the terminal box to prevent rub‐
bing or pressure marks on the cables.
● The connections of the motor windings in the terminal box
may not be removed.
MAD / MAF Asynchronous Housing Motors 177/265
Connection techniques
R911295781_Edition 11 Bosch Rexroth AG