Bosch Rexroth IndraControl XFE 01.1 Series, Operating Manual

Page: 28 / 36

28 / 36 IndraControl XFE 01.1
Error messages of the status LEDs
Bosch Rexroth AG R911345570, Edition 06
LED LED display Cause
BF Red
•
Master:
LED flashes (2 Hz): Configuration error: Not all configured I/O
devices are connected
LED on (together with SF “red on"): Hardware problem, field
bus stack cannot be loaded or there is no valid master license.
LED on (together with SF “red on"): No link, double IP, Hidden
Loop
•
Slave:
LED flashes (2 Hz): No data exchange
LED on: No configuration or slow physical connection, no phys-
ical connection or double IP
During normal mode (without errors), the LEDs “SF” and “BF” can also be on, but at low
intensity. This does not signal an error state. Check, whether additional diagnostic information
in available in the diagnostic log.
Table 19: Profibus
LED LED display Cause
Stat LED is acycli-
cally on
Module not configured
BF LED is perma-
nently on
No connection
LED flashes Slave diagnostics
Table 20: Sercos
LED LED display Cause
S LED is off No data is sent
L LED is off No connection present
Table 21: CAN
LED LED display Cause
PW LED is off Voltage error of the CAN voltage
ERR LED is red Bus error, refer to the CANopen standard “CIA 303 Part 3: Indicator
Specification”
RUN LED is off Communication error, refer to the CANopen standard “CIA 303 Part
3: Indicator Specification”
13.1.1 Error cases after commissioning the CAN module
The following errors can be displayed when commissioning the CAN module, also refer to
⮫
Chapter 11.1 “Commissioning notes ” on page 24 :