
LED
Display
Description
Action
HD
LED flashing
green
Hard disk access
–
LED is flashing
green with a
flashing
frequency of
approx. 2 Hz
①
Warning: SMART analysis is identifying
errors.
Observe that this warning message is not
displayed if RAID is used
Exchange hard disk
Reset
LED is red
Monitoring LED for the “Reset” button. The
LED is on as long as the “Reset” button is
pressed
–
①
Provided that the IPC Service program (IPCSvc) is installed
Tab. 12-1: LEDs for operating and error display on the connector panel
Wrong initialization of the CDI interface and no
image output at the connected display VDP xx.3
if the input voltage has been switched on too
early
NOTICE
If the control cabinet PC is shut down under Windows and the 24 V input
voltage is switched off, the input voltage can only be switched on again when
the V
IN
LED is off.
12.4 Backing up remanent data
An additional UPS is required to back up remanent data for the controls
IndraMotion MLC VPB 40.4. When the 24 V supply voltage fails, the UPS signals
the control firmware to back up remanent data on the hard disk. These are
restored upon the next control startup.
No backup of remanent data is possible when pressing the “Reset”
button on the IndraControl VPB.
12.5 Hypervisor
The system solution IndraMotion MLC based on the hardware IndraControl VPB
combines the functionality of a Windows HMI PC with the one of a control.
Therefore, the Windows operating system and the VxWorks operating system of
the IndraMotion MLC control have to be parallely operated on the IndraControl
VPB hardware.
This task is performed by the integrated hypervisor. The hypervisor splits the
hardware resources and assigns them exclusively to the Windows or the control
operating system. Windows and running Windows application thus cannot
directly access the resources of the integrated control. This architecture ensures
IndraControl VPB 40.4
Bosch Rexroth AG
Device description
DOK-MLC***-INDRACTRLV4-IT02-EN-P
45/87
Summary of Contents for Rexroth IndraControl VPB 40.4
Page 1: ...IndraMotion MLC IndraControl VPB 40 4 Operating Instructions R911383090 Edition 02 ...
Page 88: ...Bosch Rexroth AG IndraControl VPB 40 4 82 87 DOK MLC INDRACTRLV4 IT02 EN P ...
Page 92: ...Bosch Rexroth AG IndraControl VPB 40 4 86 87 DOK MLC INDRACTRLV4 IT02 EN P ...
Page 93: ...Notes IndraControl VPB 40 4 Bosch Rexroth AG ...