Bosch Rexroth IndraControl VPB 40.3, Operating Instructions Manual, Page: 50 / 64

Errors Troubleshooting
No image output
●
Check that both CDI cables (XSER and XVID)
are connected
●
Check that the CDI cables (XSER and XVID) are
not interchanged
No or incorrect network data transmission if the
data transmission rate is set manually
The network card of the remote station has to be
able to process the same data transmission rate as
the control cabinet PC. If necessary, change the
data transmission rate in Control Panel ▶ Network
Card
Tab. 13-1: Error causes and troubleshooting
Repairs at the device by the customer are not permitted. Exceptions
are maintenance works listed in the chapter "Maintenance".
For further information in the event of repair, please contact the
Bosch Rexroth Service.
14 Maintenance
14.1 General information
Only the maintenance works at the device listed in this chapter are
permitted.
For further information in the event of repair, please contact the
Bosch Rexroth Service.
Dissolving the labeling at the device by sol-
vents!
NOTICE
●
Do not use any solvents (e. g. diluents) for cleaning!
Destruction of screw terminals, insufficient con-
tact and loss of UL certification if no copper
wire is used or due to wrong tightening torque.
NOTICE
Use only copper wire for wiring the connection terminals. Tighten the screws of
the screw terminals with the following torque:
Thread Tightening torque
M2,5 0.4 Nm
M3 0.7 Nm
Bosch Rexroth AG
Maintenance Control Cabinet PC
44/57
DOK-SUPPL*-VPB*40.3***-IT05-EN-P