DIP Switch Settings Euchner EKS-FSA
Different parameters can be set via the S1 to S8 DIP switches. A write protection
can be activated via the S1 DIP switch. In this way writing of data on the write-
read-key is prevented. The settings are used only when applying the voltage
supply.
DIP switch
Functions
Settings of the manufac‐
turer (default)
S8
OFF = write-read-key,
ON = only-read-key
OFF
S7 - S2
OFF
S1
ON = write protection for write-read-key
OFF
Fig.6-11:
DIP switch settings Euchner EKS-FSA
6.2.7
Connection Module VAC 30.2
General Information
Device variants with the "AB" abbreviation in the type designation code have a
VAC 30.2 connection module for connecting an IndraControl VEH 30.1,
VEH 30.2 or VCH 08.1 hand-held terminal in stop button variant.
At the rear side all interfaces for wiring the connection module firmly with the
control are provided. The front panel features a 17-pin female connector with
screwed plug. The IndraControl VEH 30.1, VEH 30.2, or VCH 08.1 hand-held
terminals in stop button variant can be connected comfortably.
I ndr a Cont r ol V
Fig.6-12:
Connection module for hand-held terminals VEH 30.1, VEH 30.2 or VCH
08.1
Enabling Button of the Hand-Held Terminals IndraControl VEH 30.1, 30.2 or VCH 08.1
The hand-held terminals IndraControl VEH 30.1, VEH 30.2 or VCH 08.1 are
provided with a 2-circuit, 3-stage enabling button operated by two actuators
integrated in the rear of the housing. Further information is contained in the
documentations of the hand-held terminals IndraControl VEH30.1 (DOK-
SUPPL*-VEH*30.1***-PR02-EN-P), IndraControl VEH 30.2 (DOK-SUPPL*-
VEH*30.2***-PR01-EN-P) or IndraControl VCH 08.1 (DOK-SUPPL*-
VCH*08.1***-PR01-EN-P).
DOK-SUPPL*-VAM*XX.1***-PR02-EN-P
Rexroth IndraControl VAM 12.1/42.1 Machine Control Panels
Bosch Rexroth AG
49/93
Module Design
