Procedure:
1. To confirm the entries, click SUBMIT.
2. To clear the entries that have not yet been saved, click RESET.
3. Your entries are applied after a software reset. To reset the software,
click "Administration" in the navigation bar and then Software Reset.
The power supply of the field bus coupler can be switched off and on
again.
The following table explains the parameters listed on the site:
Port settings
Description
FTP
When the "Enabled" checkbox is selected, the file transfer pro‐
tocol (FTP) is active.
HTTP
When this "Enabled" checkbox is selected, the web server
(WBM) is active.
TCP Services
Set the port numbers for Bosch Rexroth-specific services here
Tab. 8-4:
Describing parameters of the "Port Configuration" page
8.6
"Sercos Identification" Page
This page provides status information on the field bus interface of the Sercos
field bus coupler. In addition, the electronic type plate of the field bus coupler
is displayed and the Sercos address can be set.
Fig. 8-5:
Describing parameters of the "Sercos Identification" page
DOK-CONTRL-S67S3BKDI8*-AP03-EN-P
Rexroth IndraControl S67 Sercos Coupler 8 Digital Inputs (M8)
Bosch Rexroth AG
51/139
Web-Based Management (WBM)
