10
Mounting, Dismounting and Electrical Installation
10.1
Installation Notes
●
Do not lay the cables in parallel to motor cables or other strong sources
of interference over longer distances as otherwise interference could be
coupled in.
●
Keep as much distance as possible to noise sources
●
The LED displays on the control panel must not be covered.
●
Lay all connecting cables in loops. Use strain reliefs for all cables.
●
Keep as much distance as possible to noise sources
●
Provide the following minimum distances for sufficient cooling:
30 mm
30 mm
30 mm
100 mm
100 mm
Fig.10-1:
Minimum distances for the circulation of surrounding air
If there are several rows of function modules, the supply air has to be
measured under each row and its limit value must be observed. For in‐
formation on surrounding air temperature, please refer to
"Ambient Conditions" on page 15
●
Additionally, provide sufficient distance for mounting, dismounting, con‐
nector and cable length.
DOK-CONTRL-IC*LX5*****-IT01-EN-P
Rexroth IndraControl L25, L45, L65 and L85 Controls
Bosch Rexroth AG
25/65
Mounting, Dismounting and Electrical Installation
