5-16
Instructions for Use
Rexroth EcoDrive Cs
DOK-ECODR3-DKC*CS*UL**-IB01-EN-P
5. Connect connector attached to the battery to one of the two mating
connectors on the drive controller
batteriefach_front.fh7
W
V
U
RB2
RB3
RB1
DL2
DL1
L2C
L1C
L3
L2
L1
mating connector
connector
battery
6. Attach battery cover. Push cover upwards until it snaps in
7. Dispose old battery according to the valid directions of your country
5.4 Installation
General Information on How to Install the Drive Controller
Damage can be caused to the drive controller or circuit boards if
electrostatic charging present in people and/or tools is discharged across
them. Therefore, please note the following information:
CAUTION
Electrostatic charges can cause damage to
electronic components and interfere with their
operational safety!
⇒
Exposed conductive parts coming into contact with
components and circuit boards must be discharged
by means of grounding. Otherwise errors may occur
when triggering motors and moving elements.
Such exposed conductive parts include:
•
the copper bit when soldering
•
the human body (ground connection caused by touching a conductive,
grounded item)
•
parts and tools (place them on a conductive support)
Endangered components may only be stored or dispatched in conductive
packaging.
Courtesy
of
CMA/Flodyne/Hydradyne
▪
Motion
Control
▪
Hydraulic
▪
Pneumatic
▪
Electrical
▪
Mechanical
▪
(800)
426-5480
▪
www.cmafh.com
