Bosch rexroth ctrlX AUTOMATION, Quick Start Manual

Page: 12 / 36

12 ctrlX AUTOMATION First Steps
Step 3 – Connecting the ctrlX CORE to the engineering PC
Bosch Rexroth AG R911403760 Edition 01
XG21
XG31
XF10
XF50
XF51
XG41
XF24 P2
XF23 P1
GB01
XD10
XD10 24 V connection point (voltage supply for “ctrlX DRIVEplus” and ctrlX
CORE)
XF10 ctrlX CORE engineering port (HMI)
XF50 ctrlX CORE field bus (Ethercat)
XF51 ctrlX CORE is not assigned
Commissioning the control
Connect the XD10 connection point of the “ctrlX DRIVEplus” device to a
suitable 24 V supply. For specifications on the voltage supply, refer to the
“ctrlX DRIVEplus” project planning manual.

When the 24 V supply is applied to the connection point, the control is
started. The startup can take a moment (ca. 2 minutes).
5.3 Step 3
–
Connecting the ctrlX CORE to the engineering
PC
After the control has been commissioned in step 2, the control and the engi-
neering PC are connected in this step (network connection).
Setting up a connection
Connect the engineering port (XF10) of the control to the network input
of the engineering PC

The control logs into the network configuration of the engineering PC
automatically
The control can also be integrated into an existing network. Note that the con-
trol and the engineering PC have to be in the same subnet. Otherwise, the con-
trol is not displayed in ctrlX WORKS.