Bosch Rexroth CC-ErgoSpin, Installation Instructions Manual, Page: 66 / 110

66 /110 Bosch Rexroth AG ErgoSpin/CC-ErgoSpin | 3608870DD4/2015-09
About this document
1.3.2 Symbols
The following symbols indicate information
that is not safety-relevant but increases the
understanding of the documentation.
1.3.3 Designations
This documentation uses the following desig-
nations:
Tab.2: Hazard classes as defined in ANSI Z535.6-2006
Warning symbol, signal word Meaning
DANGER
identifies a dangerous situation that will result in
death or serious injuries if it is not avoided.
WARNING
identifies a dangerous situation that may result in
death or serious injuries if it is not avoided.
CAUTION
identifies a dangerous situation that may result in mi-
nor to moderate injuries if it is not avoided.
NOTE
Damage to property: The product or the environment
may be damaged.
Tab.3: Meaning of the symbols
Symbol Meaning
If this information is disregarded, the
product cannot be used and/or op-
erated to the optimum extent.

Step
Tab.4: Designations
Designation Meaning
BS B edien s ystem (operating sys-
tem): Operating program of
the tightening system
CS351E… C ompact S ystem 351
E rgoSpin (compact system
351 ErgoSpin): Single-chan-
nel tightening system for
ErgoSpin and CC-ErgoSpin
CC-CS351E-D Single-channel tightening
system for CC-ErgoSpin
CC-ErgoSpin C urrent C ontrol (current con-
trol): Current-controlled
ErgoSpin handheld nutrunner
ESA E rgo S pin right- a ngle nutrun-
ner: ErgoSpin right-angle nut-
runner
CC-ESA Current-controlled ErgoSpin
right-angle nutrunner
ESM E rgo S pin M ittelgriffschrau-
ber: ErgoSpin pistol grip nut-
runner