Cookware test
en
17
Display
Setting
Value
MoveMode
Allows you to change the preset power levels
for the three cooking areas of the flexible
cooking zone.
Select one of the two cooking zones, set the
required power level in the settings area and
touch
to confirm the new power level and
select the next cooking zone.
- Preset power level for the front cooking zone.
- Preset power level for the middle cooking zone.
. - Preset power level for the rear cooking zone.
Cookware test
You can use this function to test the quality
of the cookware.
- Not suitable.
- Not optimal.
- Suitable.
FlexInduction
Change the switch-on mode for the Flex
Zone.
- As two independent cooking zones.
1
- As a connected cooking zone.
Restoring factory settings
- Individual settings
1
.
- Factory settings.
1
Factory setting
19.2 To go to the basic settings
Requirement:
The hob must be switched off.
1.
To switch on the hob, touch .
2.
Within the next 10 seconds, press and hold for 4
seconds.
Product information
Display
Directory for the technical after-sales
service (TK)
Production number
Production number 1
.
Production number 2
.
a
The first four displays provide the product informa-
tion. To call up the individual displays, touch the
control panel.
3.
Touch to access the basic settings.
a
and light up as a presetting.
4.
Touch repeatedly until the desired setting ap-
pears.
5.
Select the required setting in the settings area.
6.
Touch and hold for 4 seconds.
a
The settings are saved.
19.3 Discarding changes to the basic
settings
▶
Touch .
a
All changes are discarded and not saved.
20 Cookware test
The quality of the cookware has a major influence on
the speed and the result of the cooking process.
You can use this function to test the quality of the cook-
ware.
Before the test, ensure that the size of the cookware
base corresponds to the size of the cooking zone be-
ing used.
Access is via the basic settings. →
20.1 Carrying out Cookware test
As a single cooking zone, the flexible cooking zone is
set in such a way that only the individual item of cook-
ware is checked.
1.
At room temperature, place the cookware with ap-
prox. 200 ml water in the centre of the cooking zone
that best fits the base of the cookware in terms of
size.
2.
Call up the basic settings and select .
3.
Touch the settings area. The display flashes in
the cooking zones.
a
The test is running.
a
After 10 seconds, the result appears in the cooking
zone displays.
20.2 Checking the result
You can see what the result means for the quality and
speed of the cooking process in the following table.
Result
The cookware is not suitable for the cooking zone
and therefore does not heat up.
The cookware is taking longer to heat up than ex-
pected and cooking is not progressing as well as
it ought to.
The cookware is heating up correctly and cooking
is progressing well.
To activate this function, touch the settings range.
