Hood connection
en
43
e
Hood connection
Hood connection
You can connect this appliance to a suitable extractor
hood and control the functions of the hood via your
hob.
There are various options for connecting the appliances
together:
Home Connect
Two appliances can be connected using the Home
Connect app provided that both of them are Home
Connect-compatible.
Observe the supplied Home Connect documents for
this.
Connecting appliances directly
If the appliance is directly connected to a cooker hood,
connection to the home network is no longer possible.
The appliance functions in the same way as a hob with
no network connection. The hob can always be
operated via the control panel.
Connecting appliances via the home network
If the appliances are connected to each other via your
home network, both the hood controls and Home
Connect can be used to operate the hob.
Notes
■
Make sure you follow the safety instructions in the
instruction manual for your extractor hood and that
these are also observed when operating the
appliance via the hood controls on the
"Important safety information" on page 6
■
Using the controls on the extractor hood always
takes priority. It is not possible to use the hood
controls on the hob during this time.
■
In networked standby mode, your appliance requires
max. 2 W.
Setting up
To set up the connection between the hob and the
extractor hood, the hob must be switched on.
Connecting directly
Make sure that the extractor hood is switched off.
For more information refer to the section entitled
"Connecting to the hob" in the instruction manual for
your extractor hood.
Note:
If you connect your hob directly to the extractor
hood, it cannot be connected to your home network as
well and you will not be able to use Home Connect.
1.
Open the basic settings using the
f
touch key.
2.
Touch the "Hood controls" setting.
3.
Touch "Connect directly".
4.
You have 2 minutes to initiate the connection
process on the extractor hood.
A message will be displayed to notify you when the hob
is successfully connected to the extractor hood. The
symbols for the hood controls on the hob are displayed
in the status bar.
Connecting via your home network
You require a router that has WPS functionality.
You require access to your router.If you do not have
this, follow the steps for "Direct connection".
When you begin, make sure that the extractor hood is
on your home network.
1.
Open the basic settings using the
f
touch key.
2.
Touch the "Hood controls" setting.
3.
Touch "Connect via network".
4.
Press the WPS button on the router within the next
2 minutes.
A message will be displayed to notify you when the
hob is successfully connected to your home
network.
5.
You have 2 minutes to initiate the connection
process on the extractor hood.
A message will be displayed to notify you when the hob
is successfully connected to the extractor hood. The
symbols for the hood controls on the hob are displayed
in the status bar.
Note:
Connection can only be established when both
appliances are connected to your home network and
the connection process has been initiated for both of
them. If the time allowed for connecting has already
expired for one of the two appliances, initiate the
connection process again.
Summary of Contents for PXX9..K...
Page 1: ...en Instruction manual Hob PXX9 K ...
Page 2: ...2 Ø cm ...