Bosch PVQ F2 Series, User Manual

Page: 11 / 32

Before using for the first time
en
11
7 Before using for the first time
Configure the settings for initial start-up. Clean the ap-
pliance and accessories.
7.1 Setting the operating mode
The appliance is supplied with a preset circulating-air
mode.
When your hob is installed with an air outlet to the out-
side, you must configure the setting ⁠ ⁠ to this mode.
You can find additional information about this in the
section entitled
→
"Basic settings", Page 18
8 Basic operation
8.1 Switching the hob on and off
Switch the hob on and off using the main switch .
If you switch the appliance back on again within
four seconds after switching off, the hob starts up with
the previously stored settings.
Note:
Never operate the appliance without the metal
grease filter and the overflow container.
Switching on the hob
▶
Touch ⁠.
An audible signal sounds and the display beside
it lights up.
a
The hob is ready for use.
Switching off the hob
▶
Touch until the displays go out.
The residual heat indicator lights up until the cook-
ing zones have cooled down sufficiently.
a All cooking zones are switched off.
Note:
The hob switches off if all cooking zones have
been switched off for more than 20 seconds.
8.2 Setting the cooking zones
Select the required power level in the settings range.
Performance level
Lowest performance level
Highest performance level
Every power level has an intermediate setting. This is
marked in the control panel with the symbol.
Notes
¡
In order to protect the appliance's electronic parts
from overheating or surge currents, the hob may
temporarily reduce the power level.
¡
In order to prevent the appliance from producing ex-
cess noise, the hob may temporarily reduce the
power level.
Selecting the cooking zone and power level
1.
Touch to select the cooking zone.
a The display lights up and the symbol lights up
underneath it.
2.
Select the required power level in the settings
range.
a
The power level has been set.
Notes
¡
If you place cookware on the cooking zone before
you switch the hob on, and you touch , the cook-
ware is detected 20 seconds later. The cooking
zone is selected automatically. If the cookware is
detected, select the power level within 20 seconds,
otherwise the cooking zone switches itself off.
If you place several items of cookware down and
switch on the hob, only one item of cookware is de-
tected.
¡
If no cookware is placed on the cooking zone, the
selected power level flashes. After a certain period
of time, the cooking zone switches itself off.
Changing the power level and switching off the
cooking zone
1. Select the cooking zone.
2.
Select the required power level in the settings area
or set it to ⁠.
a
The cooking zone's power level changes or the
cooking zone switches itself off and the residual
heat indicator appears.