Bosch MMB6382M, User Manual, Page: 38 / 320

en
Cleaning and servicing
38
8.3 Cleaning the main unit
WARNING
Risk of electric shock!
An ingress of moisture can cause an
electric shock.
▶
Never immerse the appliance or
the power cord in water or clean in
the dishwasher.
▶
Do not use steam- or high-pres-
sure cleaners to clean the appli-
ance.
▶
Wipe down the main unit with a
soft, damp cloth.
8.4 Cleaning the blender
WARNING
Risk of cutting!
The blender knife has sharp blades.
▶
When cleaning and emptying the
blender jug, watch out for the
sharp blades.
▶
Never touch the edges of the
blades with bare hands.
ATTENTION!
The blender knife has sharp blades.
Improper handling may damage the
blades or the surface.
▶
Never set the blade insert down
with the blade facing downwards.
1.
Remove the measuring jug.
→ Fig.
28
2.
Remove the lid.
→ Fig.
28
3.
Turn the blender jug anti-clockwise
and remove it from the main unit.
→ Fig.
29
4.
Turn the blender jug upside down.
5.
Open the retaining bracket.
→ Fig.
30
6.
Remove the EasyClick blade insert
from the blender jug.
→ Fig.
30
7.
Clean the components.
8.5 Cleaning the To-Go
blender jug and To-Go
blade insert
ATTENTION!
The blender knife has sharp blades.
Improper handling may damage the
blades or the surface.
▶
Never set the blade insert down
with the blade facing downwards.
1.
Turn the To-Go blade insert anti-
clockwise and remove it from the
To-Go blender jug.
→ Fig.
31
2.
Turn the lid anti-clockwise and re-
move it from the To-Go blender
jug.
→ Fig.
32
3.
Open the mouthpiece on the lid.
→ Fig.
32
4.
Remove the seal.
→ Fig.
32
5.
Clean the components.
8.6 Using the cleaning pro-
gramme
You can use the cleaning pro-
gramme to preclean the blender jug
and the blade insert.
Requirements
¡
The blade insert is installed.
¡
The blender jug has been attached
and locked.
¡
The blender jug is filled with clean-
ing fluid (700 g water + 1 drops of
washing-up liquid).
¡
The lid is attached and locked.
¡
The rotary switch is set to ⁠.
1.
Set the rotary switch to ⁠.
→ Fig.
9
a
The status display (LED) on the
rotary switch lights up.