Bosch MIC IP starlight 7000i, User Manual

Page: 27 / 86

AUTODOME IP starlight 7000i Camera | en 27
Bosch Security Systems User Manual 2020-07 | v0.7 |
Noise reduction
Turns on/off the 2D and 3D noise reduction
If you select
Auto , the camera will adjust the 2D and 3D noise reduction level automatically.
2D noise reduction level
This field operates in conjunction with the field Noise reduction to reduce the noise
introduced by the brightness of the image. When Noise reduction is set to “On,” then the 2D
noise reduction level field is active.
Select the appropriate level of noise reduction, from 1 to 5 (2 is the default).
3D noise reduction level
This field operates in conjunction with the field Noise reduction to reduce the noise
introduced by movements in the scene. When Noise reduction is set to “On,” then the 3D
noise reduction level field is active.
Select the appropriate level of noise reduction, from 1 to 5 (2 is the default).
Intelligent Dynamic Noise Reduction
Select On to activate intelligent Dynamic Noise Reduction (DNR) which reduces noise based
on motion and light levels.
5.2.3 Scene Mode Scheduler
The scene mode scheduler is used to determine which scene mode should be used during the
day and which scene mode should be used during the night.
1.
Select the mode you wish to use during the day from Marked range drop-down box.
2. Select the mode you wish to use during the night from Unmarked range drop-down box.
3. Use the two slider buttons to set the Time ranges .
5.3 Encoder Profile
For the video signal encoding, you can select a code algorithm and you can change the presets
for the profiles.
You can adapt the video data transmission to the operating environment (for example network
structure, bandwidth, data load). To this end, the camera simultaneously generates two data
streams (Dual Streaming), which compression settings you can select individually, for example
one setting for transmissions to the Internet and one for LAN connections.
Pre-programmed profiles are available, each giving priority to different perspectives.
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
!
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
Note: In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections.
Notice!
All parameters combine to make up a profile and are dependent on one another. If you enter a
setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.