Bosch MIC IP starlight 7000i, Installation Manual

Page: 33 / 66

MIC IP starlight 7000i (Optional) Canting the Camera | en 33
Bosch Security Systems Installation Manual 2019-11 | 2.1 |
9 (Optional) Canting the Camera
Note:
For simplicity, the graphics in this section are only of the camera (and the specific accessory
that you are installing, if applicable). The graphics do not depict other accessories that you
may have installed already.
MIC7000 / MIC IP starlight 7000i cameras have on-site canting functionality.
Installers can adjust the camera from an upright position to a canted position (45º angle) if
necessary. In this position, the field of view (FOV) of the camera includes the scene directly
beneath the camera.
You cannot install a canted unit in inverted orientation (with the camera head down). The tilt
limits of the camera prevent correct operation in inverted and canted orientation.
!
Warning!
Risk of bodily injury.
Unplug the device from its power source before canting the device. After removing the screws
from the yoke arms, support the camera head so that it doesn't tilt downward unexpectedly
and pinch fingers or other body parts.
Notice!
Risk of damage to the camera
Do not, under any circumstances, cant the camera while the camera is on its side. Cant the
camera from an upright position only, in order to prevent screws or other objects from falling
into the open spaces in the arms when the yoke caps are removed.
Figure 9.1: Do NOT allow screws or other objects to fall inside camera!
!
Warning!
Risk of bodily injury
Do not put a canted (45°) camera in an upright position on the camera base or on an
unsecured DCA. In this position, the camera can fall over and can cause injury or be damaged.
Put the canted camera on its side until installation.
Notice!
Install the applicable accessories (illuminator, sunshield) before you cant the camera.