Bosch MIC IP starlight 7000i, Installation Manual

Page: 26 / 66

26 en | (Optional) Installing the Illuminator MIC IP starlight 7000i
2019-11 | 2.1 | Installation Manual Bosch Security Systems
8 (Optional) Installing the Illuminator
Use the correct set of tools as well as the recommended torque values given in the
instructions that follow. The use of the wrong tools or torque values may cause damage to
threads or seal caps, which may result in leaks or damage to paint, which then may lead to the
start of corrosion.
Parts List
Quantity Component
1 MIC Illuminator accessory
1 Spanner wrench [to remove the access plug from the camera head]
3 M4x10 socket head Torx screws
1 Quick Installation Guide
Additional Tools Required
1 Torx driver, T20, for M4 Torx screws
1 Phillips-head screwdriver, #2,
to remove factory-installed plastic screws from the camera head
!
Warning!
IR emitted from this product.
Meets IEC 62471, Risk Group 1.
Notice!
This product has been tested according to standard IEC62471:2006 “Photobiological safety
of lamps and lamp systems”. The product emissions exceed the EXEMPT Group limit for both
Retinal Blue Light and Cornea/Lens infrared hazard as defined by IEC 62471:2006. The
product was found to meet the Risk Group 1 exposure limits for IR and White LEDs.
Refer to the MIC7000 Operation Manual for complete information on illumination safety.
Notice!
If the MIC camera will have both illuminator and sunshield accessories, install the illuminator
first.
1. Mount the camera or stand it temporarily in the packaging foam on a stable surface before
proceeding. (Refer to the Operation Manual.)
If the camera will be mounted inverted, you must rotate the tilt head before attaching the
illuminator.
1.
Apply power.
2. Connect to your network.
3. From the web browser, access the camera’s Configuration page. Select Camera >
Installer Menu > Orientation.
4. Select “Inverted”. Click Set to confirm the selection. The camera head will rotate
automatically into inverted position (180°).
Regardless of mounting orientation, the visor should always be above the camera window.
Apply power and connect to your network as illustrated in the figure below.