2 610 A12 917 | (19.1.10)
Bosch Power Tools
28
| English
Attaching with the Holder (see figure A)
With the holder
17
, the measuring tool can be fastened to a con-
struction laser measuring rod
15
(accessory) as well as to other
auxiliary tools with a width of up to 65 mm.
Screw the holder
17
to the retainer opening
12
on the rear side of
the measuring tool with fastening screw
16
.
Loosen the locking screw
13
, slide the holder onto the construc-
tion laser measuring rod
15
, for example, and retighten the locking
screw
13
.
The upper edge
14
of the holder is located at the same height as
the centre mark
5
and can be used for marking of the laser beam.
Attaching with the Magnet (see figure B)
When a positive-lock attachment is not absolutely required, the
measuring tool can be attached to steel parts via the face side us-
ing the magnet plate
4
.
Maintenance and Service
Maintenance and Cleaning
Keep the measuring tool clean at all times.
Do not immerse the measuring tool in water or other fluids.
Wipe off debris using a moist and soft cloth. Do not use any clean-
ing agents or solvents.
If the measuring tool should fail despite the care taken in manufac-
turing and testing procedures, repair should be carried out by an
authorised after-sales service centre for Bosch power tools. Do not
open the measuring tool yourself.
In all correspondence and spare parts orders, please always in-
clude the 10-digit article number given on the type plate of the
measuring tool.
OBJ_BUCH-780-003.book Page 28 Tuesday, January 19, 2010 10:56 AM