1 689 989 289
2014-12-04
|
Robert Bosch GmbH
Initial start-up | KTS 530 / 540 / 570 (KTS 5 Series) | 25
en
4.4
Configuration (DDC)
i
The function of the DDC (Diagnostic Device Configu-
ration) software is to configure, activate and test the
KTS modules.
1.
Starting DDC ("
Start >> Programs >> ESI[tronic] >>
Diagnostic Device Configuration
").
2.
Add the KTS module via "
New
".
i
Other procedures for configuration concerning the
initial start-up are described in the online help. Use
<
Help
> to open the online help. All other important
information concerning DDC is found here as well.
i
If you have any questions which cannot be answered
by the online Help, please contact the ESI[tronic]
service hotline directly.
4.5
Assembly mount
The mount included with the delivery allows fastening
and loosening the KTS modules on the Bosch trolley
(possible as of production date 03-2006 only).
1.
Screw in the three fillister head screws on the Bosch
trolley (see Fig. 4).
BOSCH
CH2
CH1
DIA
G
max.
60V
KTS 570
P o w e r e d b y
ESI tronic
wireless
45980213
2 mm
Fig. 4:
Assembly mount
2.
Using the sheet-metal screws included with the de-
livery, screw the mount onto the KTS module (holes
for mounting are on the rear of the module).
3.
Correct the screw penetration of the fillister head
screws on the vehicle so that the KTS modules are
solidly and securely seated in position following
installation.
