1 689 989 293
2020-08-24
|
Robert Bosch GmbH
| 22 | KTS 350 (KTS 3a Series) | Operation
5.8
On-screen keyboard
The KTS 350 features a virtual keypad. Pressing the
icon in the task bar or pressing the function key ƒ for
> 2 seconds opens or closes the on-screen keyboard
as applicable.
The on-screen keyboard functions in the same way as
a conventional keyboard. The following setting options
are available:
If calling up a function on a standard keyboard would
involve pressing two keys simultaneously (e.g. <
Alt
>
+ <
F4
>), these keys are to be pressed consecutively
on the on-screen keyboard. The special keys <
Shift
>,
<
Alt
> and <
Ctrl
> must always be pressed first.
!
On account of software programming differences, it
cannot be guaranteed that the on-screen keyboard
keypad will work with every type of software.
5.9
System settings
The power plan settings and the screen brightness can
be altered under "
Start >> Control panel >> Power
options
" or by pressing and holding the
icon
with the stylus.
5.9.1
Volume adjustment
By clicking on the icon in the task bar with the
stylus, the volume of the KTS 350 can be adjusted.
5.9.2
Calibrating touch screen
The purpose of the "eGalaxTouch" application is to
calibrate the touch screen in the respective view
(horizontal or vertical).
1. Start "
eGalaxTouch
" with a double click on the
touch screen.
2.
Under the
Tools
tab, select <
Linearization
>
(9-point linearization) or <
4-point calibration
>.
i
Bosch recommends the 9-point linearization in
order to achieve sufficiently accurate calibration of
the touch screen.
3.
Touch
calibration or linear points
with the stylus
and hold until the OK symbol appears.
i
To avoid errors, the line of vision must be vertically
above the calibration point. Click onto the
calibration point as accurately as possible.
4.
On completion of calibration, end the application
with <
OK
>.
"
This completes the calibration.
5.10 Print
A printer (e.g. PDR 377) can be connected by way of
the USB interface of the KTS 350.
i
For details of printer drivers and installation see
the printer manufacturer's information
i
Information on printing can be found in the online
help for the Bosch applications.
5.11 Troubleshooting
Fault
Note
The KTS 350 cannot be
switched on and the
display remains blank.
The capacity of the internal storage
battery is not sufficient to start the
KTS 350.
Connect the external power supply
unit.
KTS 350 does not
react to any key
command.
1. Press and hold the ON button for
5 seconds.
2. Switch on the KTS 350 again.
This switch-off procedure is only to
be employed if the KTS 350 will not
react to any key being pressed. This
may result in loss of data on the hard
disk if it is implemented during regular
operation. Data created in the course
of this diagnostic application may have
to be entered again.
After clicking onto
the touch screen with
the stylus, the mouse
pointer does not appear
at the same location
Touch screen calibration must be
performed.
Under "
START
>> Programs
>> eGalaxTouch",
select the
"eGalaxTouch
" menu, see sec. 5.9.2
Operation by way
of stylus and touch
screen is no longer
possible.
Touch screen calibration must be
performed. Connect the mouse or
keyboard.
In the start bar under "
START
>> Control panel",
select the
"
eGalaxTouch
", see sec. 5.9.2
en
Summary of Contents for KTS 350
Page 2: ......
