Bosch KDD Series, Instructions For Use Manual

Page: 47 / 136

en
47
Eliminating minor faults yourself
Before you call customer service:
Please check whether you can eliminate the fault yourself based on the following
information.
Customer service will charge you for advice – even if the appliance is still under
guarantee!
Fault Possible cause Remedial action
Temperature differs greatly
from the set value.
In some cases it is adequate to switch off
the appliance for 5 minutes.
If the temperature is too high wait a few hours
and check whether the temperature has
approached the set value.
If the temperature is too low check
the temperature again the next day.
It is too cold in the
refrigerator section or in the
chill compartment.
Increase the temperature in the refrigerator
section.
Push temperature controller for the chill
compartment downwards. Fig.
(
The temperature in the
freezer section is too warm.
Appliance opened
frequently.
Do not open the appliance unnecessarily.
The ventilation openings
have been covered.
Remove obstructions.
Large quantities of fresh
food are being frozen.
Do not exceed the freezing capacity.
Appliance is not cooling,
temperature display and light
are lit up.
Showroom mode is switched
on.
Press and hold freezer/fridge button for
15 seconds.
"77" appears briefly on the control panel.
After a short time check whether your
appliance is cooling.
The side panels of the
appliance are warm.
Pipes run into the side panels
which heat during the
cooling process.
That is normal behaviour for the appliance and
not a fault.
Furniture touching the appliance will not be
damaged by the heat.