21
Connecting to liquefied gas
Model HSG738155M and HSG736155M:
If you connect the appliance to liquefied gas, you must always
install a suitable gas pressure regulator. Use the total gas
consumption of the appliance stated on the rating plate to
select a suitable gas pressure regulator.
Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
1.
Screw the bend (3) and the seal (2) to the gas connection
(1).
2.
Screw the hose connection (5) and the seal (4) to the bend
(3).
3.
Slide a flexible gas connecting hose (7) onto the corrugated
tube union (5).
4.
Pull the clamp (6) tight.
Only use approved sealing compound to seal the thread.
Model HSG732155M:
If you connect the appliance to liquefied gas, you must always
install a suitable gas pressure regulator. Use the total gas
consumption of the appliance stated on the rating plate to
select a suitable gas pressure regulator.
Only use connecting lines or flexible hoses which comply with
the applicable regulations and which are approved for this
purpose.
1.
Screw the corrugated tube union (3) and the seal (2) to the
gas connection (1).
2.
Slide a flexible gas connecting hose (5) onto the corrugated
tube union (3).
3.
Pull the clamp (4) tight.
Only use approved sealing compound to seal the thread.
Flexible hose
If you use flexible hoses, make sure that:
■
the hoses do not become trapped or squashed.
■
the hoses are not subject to twisting or pulling forces.
■
the hoses, for example, do not come into contact with sharp
edges or cutting edges.
■
the hoses do not come into contact with parts that could
reach a temperature higher than 70 °C above room
temperature.
Make sure that the full length of the hoses is accessible for
inspection.
Installing the safety valve
The installation of a safety valve for opening and closing the
gas supply is a compulsory requirement. Fit the safety valve
between the gas supply line to the appropriate room and the
appliance. Ensure unhindered access to this valve.
Checking for leaks
After connecting the gas line, check the connections for leaks
using soapy water.
Initial use
Switch the appliance on as described in the instructions for
use. Light all the burners and check that the flames remain
stable at both the high and low settings.
Summary of Contents for HSG732155M
Page 2: ......
Page 72: ... المستقل الموقد ar والتركيب ااستعمال دليل 9000808452 920719 ...
