Bosch HGN21F350I, Instruction Manual

Page: 10 / 28

10
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels from the
oven door.
Removing the door panels
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using the locking pin.
Note:
The locking pins must be fully inserted into the holes in
the hinges.
3.
Lift the bottom of the inner panel slightly until the fastening
pins come out of the holder (
1
).
4.
Carefully lift the top of the inner panel until the fastening pins
come out of the holder (
2
).
Caution!
When lifting the inner panel, the middle panel may stick to the
inner panel. Make sure that the middle panel does not fall.
5.
Remove the inner panel.
6.
Remove the middle panel.
Note:
The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the door panels
1.
Reinsert the middle panel.
Note: Make sure that the panel is seated correctly. All rubber
bushings must lay flat against the outer panel.
2.
Reinsert the inner panel.
Note:
All four fastening pins must engage in the holders
provided for them.
3.
Remove the locking pins and close the oven door.
Removing and fitting the appliance door
If the oven is very heavily soiled, the oven door can be removed
for easier cleaning. Normally, however, this is not necessary.
Removing the appliance door
1.
Open the oven door fully.
2.
Lock both hinges on the left and right using the locking pin
(a)
.
Note: The locking pins must be fully inserted into the holes in
the hinges.
3.
Grip the oven door on either side with both hands and close
the oven door by approx. 30° (b) .
4.
Raise the oven door slightly and pull it out.
Note:
Do not fully close the oven door. The hinges could
become bent and the enamel could be damaged.
D E