Bosch HGI10TQ50, Instruction Manual

Page: 14 / 24

14
Before using for the first time
Before using for the first time
In this section, you can find out what you must do before using
your oven or hob to prepare food for the first time. Read the
following section beforehand.
Remove the appliance packaging and dispose of it
appropriately.
Baking out the oven
Precleaning the oven
1.
Remove accessories and hook-in racks from the cooking
compartment.
2.
Fully remove any remaining packaging, such as small pieces
of polystyrene, from the cooking compartment.
3.
Some parts are covered with a protective film. Remove the
protective film.
4.
Clean the outside of the appliance with a soft, damp cloth.
5.
Clean the cooking compartment with hot soapy water.
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed.
1.
Turn the temperature selector to the maximum temperature.
2.
Switch off the oven after 45 minutes.
Cleaning the burner caps and cups
1.
Clean the burner caps (A) and cups (B) with water and
washing-up liquid.
2.
Dry the parts well.
3.
Place the burner cup (B) onto the burner (C).
4.
Position the burner cap (A) exactly on the burner cup (B).
Cleaning the accessories
Before using the accessories, clean them thoroughly using a
cloth and warm soapy water.
Operating the appliance
Operating the appliance
You have already learnt about the controls and how they work.
Now we will explain how to set your appliance. You will learn
about what happens when you switch the appliance on and off,
and how to select the operating mode.
Hob
Switching on the gas burner
Notes
■
Appliances with a hob cover must only be switched on if the
hob cover is open.
■
The burner caps must always be positioned exactly on top of
the burner cups. The slots on the burner cup must be free
from obstruction. All parts must be dry.
■
Ensure that the burner is not subjected to draughts caused
by air conditioning systems, fans or similar appliances.
1.
Press the control knob for the hotplate you require and turn it
to the — position.
Press and hold the control knob and press the ignition button
for the gas hotplates.
Gas will begin to flow out and the gas burner will ignite.
2.
Press and hold the control knob for a few seconds until the
flame stabilises.
3.
Select the required setting.
The flame is not stable between positions Û and — .Always
select a position between — and ˜ .
If the flame goes out
Switch off the control knob. Wait one minute and switch the
burner on again.
:
Risk of fire!
If the flame goes out, gas will escape. Never leave the gas
burner unattended during operation. Ensure that there are no
draughts.
If the gas burner does not ignite
In the event of a power cut or damp ignition plugs, light the gas
burner with a gas lighter or a match.
Switching off the gas burner
Turn the control knob for the required hotplate to position Û .
$
%
&
Setting Meaning
˜
Economy flame, lowest setting
—
Large flame, highest setting