en
Home Connect
20
Basic setting
Selection
Brand logo
Display
1
Do not display
Fan run-on time
Recommended
1
Minimum
Pull-out system
Not retrofitted (if shelf sup-
ports and a single set of
pull-out rails are fitted)
1
Retrofitted (if two or three
sets of pull-out rails are fit-
ted)
Sabbath mode
Switched on
Switched off
1
1
Factory setting (may vary according to model)
15.2 Changing the basic settings
Requirement:
The appliance is switched on.
1.
Press
.
2.
Press "Basic settings".
3.
Press the required basic setting and use the control
ring to change it.
The red bar next to the text field identifies the basic
setting that is currently selected. Its corresponding
value is shown in the display.
4.
Use "Further settings" to scroll through the basic
settings and, if required, use the control ring to
change any of these settings.
5.
To save your changes, press
and use "Save"
to confirm.
Note:
Your changes to the basic settings will be re-
tained even after a power failure.
Discarding changes to the basic settings
▶
Press
and use "Do not save" to confirm.
a
All changes will be discarded and not saved.
15.3 Setting the time
Requirement:
The appliance is switched on.
1.
Press
.
2.
Press "Basic settings".
3.
Press "Time".
4.
Use the control ring to change the time.
5.
To save your changes, press
and use "Save"
to confirm.
16 Home Connect
This appliance is network-capable. Connecting your ap-
pliance to a mobile device lets you control its functions
via the Home Connect app, adjust its basic settings
and monitor its operating status.
The Home Connect services are not available in every
country. The availability of the Home Connect function
depends on the availability of Home Connect services
in your country. You can find information about this at:
www.home-connect.com.
The Home Connect app guides you through the entire
login process. Follow the instructions in the Home Con-
nect app to configure the settings.
Tips
¡
Please consult the documents supplied by
Home Connect.
¡
Please also follow the instructions in the Home Con-
nect app.
Notes
¡
Please note the safety precautions in this instruction
manual and make sure that they are also observed
when operating the appliance via the Home Con-
nect app.
¡
Operating the appliance on the appliance itself al-
ways takes priority. During this time it is not possible
to operate the appliance using the Home Connect
app.
¡
In networked standby mode, the appliance requires
a maximum of 2 W.
16.1 Setting up Home Connect
Requirements
¡
The appliance is connected to the power supply and
is switched on.
¡
You have a smartphone or tablet with a current ver-
sion of the iOS or Android operating system.
¡
The smartphone and the appliance are within range
of your home network's Wi-Fi signal.
1.
Download the Home Connect app.
2.
Open the Home Connect app and scan the follow-
ing QR code.
3.
Follow the instructions in the Home Connect app.
16.2 Home Connect Settings
You can adjust the settings and network settings for Home Connect by going to your appliance's basic settings.
Which settings the display shows will depend on whether Home Connect has been set up and whether the appliance
is connected to your home network.
