en
Rails
24
Removing the pull-out rails
1.
Push on the tab marked "PUSH" behind the end of
the rail, and push the rail away from you (fig.
!
).
2.
Keep the "PUSH" tab pushed back and swing the rail
out (fig.
"
).
3.
Pull the rail out towards you until the retainer at the
back unhooks (fig.
#
).
4.
Remove the pull-out rail (fig.
$
).
Use washing-up liquid and a sponge to clean the pull-
out rails. For stubborn dirt deposits, use a brush.
Fitting the pull-out rails
The rails are designed to fit on either the right- or the
left-hand side (not both).Make sure when you fit them
that you can pull them out towards you.
1.
The rail must sit between the two bars (fig.
!
).
2.
Push the retainer at the back in between the lower
and the upper bar (fig.
"
).
3.
Push on the "PUSH" tab and swing the rail in so that
the retainer ends up between the two bars (fig.
#
).
4.
Release the "PUSH" tab; the retainer will hook into
place (fig.
$
). Then pull the rail out as far as it will go
and slide it back in.
1
2
I
1
2