English - 3
The numbering of the product features refers to
the illustration of the power tool on the graphics
page.
1
Two-jaw chuck*
2
Hexagon nut
3
Lock-on button for On/Off switch
4
Speed dial for speed preselection
5
On/Off switch
6
Wing bolt for depth stop adjustment *
7
Wing bolt for auxiliary handle adjustment *
8
Auxiliary handle*
9
Depth stop*
10
Chuck key for two jaw chuck *
11
Stud-bolt chuck*
12
Rapid-change chuck *
13
Roller clutch*
14
Adapter for roller clutch *
15
Wedge*
*
Not all of the illustrated or described accessories are
included as standard delivery.
Two-jaw Chuck (see figure
)
Insert the tap into the two jaw chuck
1
and tighten
it with the two jaw chuck key
10
.
Always use the correct voltage:
The voltage of
the power source must agree with the values on
the nameplate of the tool.
Switching On and Off
To
start
the tool, press the On /Off switch
5
and
keep it pressed.
The machine runs with variable
speed between 0 and maximum
depending on the pressure applied
to the On/Off switch
5
. Light pres-
sure results in a low rotational
speed, thus allowing smooth, con-
trolled starts. Do not strain the machine so
heavily that it comes to a complete stop.
To
lock on, push and hold the On /Off switch 5
and press the lock-on button 3.
To switch off the machine, release the On /Off
switch 5 or, when locked with the lock-on but-
ton 3, briefly press the On /Off switch 5 and then
release.
Speed Preselection
With the speed dial 4, the required speed can be
selected even if the machine is running.
The required speed depends on the material and
can be determined by practical testing.
After working with the machine for long periods at
low speed, allow it to cool by letting it run for ap-
prox. 3 minutes at maximum speed with no load.
Automatic Reversing of the Rotational
Direction
The tapper is equipped with a changeover gear-
box for clockwise rotation and accelerated coun-
terclockwise reverse rotation.
Under no load, the machine runs in counterclock-
wise direction and will switch automatically to a
clockwise direction when placed against the
workpiece. Gently pulling back the machine will
cause it to run counterclockwise.
Tool Specifications
Tapper
GGW 10 E
PROFESSIONAL
Article number
0 601 462 8..
Rated power input [W]
500
Output power
[W]
270
Rated speed
- Right rotation
[rpm]
0 – 350
- Left rotation
[rpm]
0 – 600
No-load speed
- Right rotation
[rpm]
0 – 580
- Left rotation
[rpm]
0 – 1 000
Cutting capacity
for threads
M 4 – M 10
Tightening of
stud bolts
M 4 – M 12
Weight without
cable, approx.
[kg]
2.7
Safety class
/ II
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of 230/
240 V. However, these values can vary for lower voltages
and models made for specific countries.
Product Features
Inserting the Tool
Initial Operation
A
3 609 929 A82.book Seite 3 Mittwoch, 22. Februar 2006 8:40 08
6 • 3 609 929 A82 • TMS • 09.02.06
