Bosch GCM 10 J, Original Instructions Manual, Page: 27 / 345

English | 27
Bosch Power Tools 1 609 92A 0XH | (12.12.14)
Floor Strips/Mouldings
The following table contains instructions for sawing floor strips/mouldings.
Ceiling Strips/Mouldings (According to US Standard)
Checking and Adjusting the Basic Adjustment

Before any work on the machine itself, pull the mains
plug.
To ensure precise cuts, the basic adjustment of the machine
must be checked and adjusted as necessary after intensive use.
A certain level of experience and appropriate specialty tools
are required for this.
A Bosch after-sales service station will handle this mainte-
nance task quickly and reliably.
Settings Placed
against the
fence Lying flat on
the saw table
Bevel angle 0° 45°
Floor strip/moulding Left side Right side Left side Right side
Inner corner Horizontal mitre angle 45° left 45° right 0° 0°
Positioning of
workpiece Bottom edge on
saw table
Bottom edge on
saw table
Upper edge against
the fence
Bottom edge
against the fence
The finished work-
piece is located ... ... to the left of the
cut
... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
Outer corner Horizontal mitre angle 45° right 45° left 0° 0°
Positioning of
workpiece Bottom edge on
saw table
Bottom edge on
saw table
Bottom edge
against the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the right of the
cut
... to the left of the
cut
... to the right of the
cut
... to the right of the
cut
When the ceiling strips/mouldings are to be sawn lying flat on the saw table, the standard mitre angles of
31.6° (horizontal) and 33.9° (vertical) must be set.
The following table contains instructions for sawing ceiling strips/mouldings.
Settings Placed
against the
fence Lying flat on
the saw table
Bevel angle 0° 33,9°
Ceiling strip/moulding Left side Right side Left side Right side
Inner corner Horizontal mitre angle 45° right 45° left 31.6° right 31.6° left
Positioning of
workpiece Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
Bottom edge
against the fence
The finished work-
piece is located ... ... to the right of the
cut
... to the left of the
cut
... to the left of the
cut
... to the left of the
cut
Outer corner Horizontal mitre angle 45° left 45° right 31.6° left 31.6° right
Positioning of
workpiece Bottom edge
against the fence
Bottom edge
against the fence
Bottom edge
against the fence
Upper edge against
the fence
The finished work-
piece is located ... ... to the right of the
cut
... to the left of the
cut
... to the right of the
cut
... to the right of the
cut
52°
38°
52°
OBJ_BUCH-1156-002.book Page 27 Friday, December 12, 2014 10:16 AM
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com