Bosch FPE-1000-NE, Installation Manual

Page: 8 / 20

8 en | Installation FPA-1000-V2 Network Cards
2017.11 | 2.0 | F.01U.214.374 Installation manual Bosch Security Systems, Inc.
3 Installation
3.1 General considerations
Danger!
Before installing the networking card, remove all AC and battery power from the fire panel.
Caution!
Electrostatic Discharge - ground yourself
Ground yourself using a wrist strap or take other suitable actions.
The FPA-1000 circuit boards have static-sensitive components that could become damaged.
Run the ground wire to the enclosure before handling the circuit boards. Touch ground before
unpacking and handling the circuit boards. This discharges any static electricity in your body.
Continue touching the enclosure while installing the circuit boards.
3.2 Mounting
The main board allows for the installation of one networking card. See the following figure.
To install the card:
–
Position the networking card along the bottom of the mainboard keypad with the
connections aligned with the slot
– Press down softly until the snap-fit hook locks into place ensuring that the connections
seat into the slot properly
Figure 3.1: Mounting a Network Card
1 Network card 2 Connectors and slot
3 Snap-fit hook