Bosch FPC-500, Operation Manual

Page: 16 / 40

16 en | Operation Conventional fire panel
2019.07 | 5.1 | F.01U.172.982 Bosch Sicherheitssysteme GmbH
ACK
Confirm your selection in the menu with the ACK
key.
Exiting submenus
RESET
ESC
In the menu and in the submenus, you can jump to a
higher level or cancel the setting using the RESET
(ESC) key.
Hold the RESET (ESC) key down for 2 seconds to
jump to the uppermost level.
4.1 Operating Level 1
4.1.1 Actions
The following actions can be performed in level 1:
Alarm verification (if programmed)
Notice!
This procedure only applies to zones that are programmed as
alarm verification.
Note that the delay settings are only effective in day mode. In
night mode, the alarm is triggered immediately.
A zone programmed as alarm verification triggers an alarm,
which you must confirm manually.
ACK
Press the ACK button within the programmed
confirmation time.
The programmed verification time begins.
Check the area of the zone triggering the fire alarm
to see if there is really any fire.
If you have discovered a real fire, use either a
manual call point or the EVAC button to trigger the
alarm.