38
en | Configuration
FLEXIDOME panoramic 5100i | FLEXIDOME
panoramic 5100i IR
2022-01 | V01 | F.01U.385.628
User manual
Bosch Security Systems B.V.
4.6
Alarm
4.6.1
Alarm Connections
In the event of an alarm, the unit can automatically connect to a pre-defined IP address. The
unit can contact up to ten IP addresses in the order listed until a connection is made.
Connect on alarm
Select
On
so that the unit automatically connects to a pre-defined IP address in the event of
an alarm.
Select
Follows input 1
so that the unit maintains the connection for as long as an alarm exists
on alarm input 1.
Auto-connect
Select
On
to automatically re-establish a connection to one of the previously specified IP
addresses after each reboot, connection breakdown, or network failure.
Number of destination IP address
Specify the numbers of the IP addresses to be contacted in the event of an alarm. The unit
contacts the remote locations one after the other in the numbered sequence until a
connection is made.
Destination IP address
For each number, enter the corresponding IP address for the desired remote station.
Destination password
If the remote station is password protected, enter the password here.
Only ten passwords can be defined here. Define a general password if more than ten
connections are required. The unit connects to all remote stations protected by the same
general password. To define a general password:
1.
Select 10 in the
Number of destination IP address
list box.
2.
Enter 0.0.0.0 in the
Destination IP address
field.
3.
Enter the password in the
Destination password
field.
4.
Set the user password of all the remote stations to be accessed using this password.
Setting destination 10 to the IP-address 0.0.0.0 overrides its function as the tenth address to
try.
Video transmission
If the unit is operated behind a firewall, select
TCP (HTTP port)
as the transfer protocol. For
use in a local network, select
UDP
.
To enable multicast operation, select
UDP
for the
Video transmission
parameter here and on
the
Network Access
page.
Note:
In the event of an alarm, a larger network bandwidth is sometimes required for additional
video streams (if multicast operation is not possible).
Stream
Select a stream to be transmitted.
Remote port
Select an appropriate browser port depending on the network configuration.
The ports for HTTPS connections are only available if
SSL encryption
is set to
On
.
