FLEXIDOME panoramic 5100i | FLEXIDOME
panoramic 5100i IR
Configuration | en
35
Bosch Security Systems B.V.
User manual
2022-01 | V01 | F.01U.385.628
Alarm recording
Select a period for the
Pre-alarm time
from the list box. The RAM option allows the pre-alarm
recording ring buffer to be stored in RAM as long as it fits, depending on bit rate settings. This
avoids writing to the SD card or iSCSI. The pre alarm ring is written to storage only on alarm.
Select a period for the
Post-alarm time
from the list box.
Alarm stream
Select the stream to be used for alarm recordings:
–
Stream 1
–
Stream 2
–
I-frames only
Check the
encoding interval and bit rates from profile:
box and select an encoder profile to
set the associated encoding interval for alarm recording.
Export to account
To send standard H.264 or H.265 files to the target address, select an account and check
Export from memory
.
If the target has not yet been defined, click
Configure accounts
to jump to the
Accounts
page
where the server information can be entered.
Alarm triggers
Select the alarm type that is to trigger an alarm recording:
–
Alarm input
–
Analysis alarm
Select the
Virtual alarm
sensors that are to trigger a recording, via RCP+ commands or alarm
scripts, for example.
Configure accounts
Sends you to the
Accounts
page.
Copy Settings
You can copy the settings from one profile to another with the
Copy Settings
button. Select
the target profile and click
OK
.
Default
The default values are restored.
Click
Set
to apply the changes.
4.5.3
Maximum Retention Time
Recordings are overwritten when the retention time entered here has expired.
Enter the required retention time in days for each recording track.
Click
Set
to apply the changes.
4.5.4
Recording Scheduler
The recording scheduler allows you to link the created recording profiles to the days and
times at which the camera's images are to be recorded. Schedules can be defined for
weekdays and for holidays.
Weekdays
Assign as many time periods (in 15-minute intervals) as needed for any day of the week. Move
the mouse cursor over the table - the time is displayed.
1.
Click the profile to be assigned in the
Time periods
box.
2.
Click a field in the table and, while holding down the left mouse button, drag the cursor
across all of the fields to be assigned to the selected profile.
