Bosch EXTEGRA IP 9000 FX, Operation Manual

Page: 5 / 54

Browser connection
A computer with Microsoft Internet Explorer is used to receive live images, control the unit,
and replay stored sequences. The unit is configured over the network using the browser.
System requirements
– Network access (Intranet or Internet)
– Microsoft Internet Explorer version 9 (32-bit)
– Screen resolution at least 1024 × 768 pixels
– 16- or 32-bit color depth
– JVM installed
The Web browser must be configured to enable Cookies from the IP address of the unit.
In Windows Vista, deactivate protected mode on the Security tab under Internet Options.
To play back live video images, an appropriate ActiveX must be installed on the computer. If
necessary, install Bosch Video Client. This can be downloaded from the following address:
http://downloadstore.boschsecurity.com/
Establishing the connection
The unit must have a valid IP address to operate on your network and a compatible subnet
mask. By default, DHCP is pre-set at the factory to On and so your DHCP server assigns an IP
address. With no DHCP server the default address is 192.168.0.1
1.
Start the Web browser.
2. Enter the IP address of the unit as the URL.
3. During initial installation, confirm any security questions that appear.
Note:
If you cannot connect, the unit may have reached its maximum number of connections.
Depending on the device and network configuration, each unit can have up to 50 web browser
connections, or up to 100 connections via Bosch Video Client or Bosch Video Management
System.
Password protection in camera
A unit offers the option of limiting access across various authorization levels. If the unit is
password-protected, a message to enter the password appears.
1.
Enter the user name and the associated password in the appropriate fields.
2. Click OK. If the password is correct, the desired page is displayed.
Protected network
If a RADIUS server is used for network access control (802.1x authentication), the unit must
be configured first. To configure the unit, connect it directly to a computer using a network
cable and configure the two parameters, Identity and Password. Only after these have been
configured can communication with the unit via the network occur.
1
1.1
1.2
1.2.1
1.3
EXTEGRA IP 9000 FX Browser connection | en 5
Bosch Security Systems Operation Manual 2015.03 | 1.0 |