Trouble shooting
en
9
By hand:
Note:
You can use a special grease solvent for
stubborn dirt. It can be ordered via the Online Shop.
■
Soak the metal mesh grease filters in a hot soapy
solution.
■
Clean the filters with a brush and then rinse them
thoroughly.
■
Leave the metal mesh grease filters to drain.
In the dishwasher:
Note:
If the metal mesh grease filters are cleaned in the
dishwasher, slight discolouration may occur. This has
no effect on the function of the metal mesh grease
filters.
■
Do not clean heavily soiled metal mesh grease filters
together with utensils.
■
Place the metal mesh grease filters loosely in the
dishwasher. The metal mesh grease filters must not
be wedged in.
Removing metal grease filter
1.
Open the lock and fold down the metal grease filter.
While doing this, place the other hand under the
metal grease filter.
2.
Take the metal grease filter out of the holder.
For edge extraction filters, pull the metal grease filter
downwards. While doing this, place the other hand
under the metal grease filter.
For additional filters, open the lock and fold down
the metal grease filter. While doing this, place the
other hand under the metal grease filter.
Notes
– Grease can accumulate in the bottom of the
metal grease filter.
– Hold the metal grease filter level, otherwise
grease will drip out.
3.
Clean the metal grease filter.
Installing the metal mesh grease filter
1.
Insert the metal mesh grease filter.
While doing this, place the other hand under the
metal mesh grease filter.
2.
Fold the metal mesh grease filter upwards, locking it
in place.
3
Trouble shooting
Trouble shooting
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
:
Warning
Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Malfunction table
--------
Replacing bulbs
These instructions apply to several appliance variants. It
is possible that individual features are described which
do not apply to your appliance.
:
Warning
Risk of burns!
Bulbs become very hot when switched on. There is still
a risk of burning for some time after they have been
switched off. Allow the bulbs to cool down before
replacing them.
:
Warning
Risk of electric shock!
When changing the bulbs, the bulb socket contacts are
live. Before changing the bulb, unplug the appliance
from the mains or switch off the circuit breaker in the
fuse box.
Replacing the halogen bulbs
Important!
Only use bulbs of the same type and
wattage.
Problem
Possible cause Solution
The appliance
does not work
The plug is not
plugged in.
Connect the appliance to the
electricity supply
Power cut
Check whether other kitchen
appliances are working
Faulty fuse
Check in the fuse box to make
sure that the fuse for the
appliance is OK
The lighting does
not work.
The bulbs are
faulty.
For information on changing
the bulbs, see the "Replacing
Bulbs" section.
+6*678%*
