Bosch DIP-5042EZ-0HD, Installation Manual

Page: 17 / 46

DIVAR IP 5000 Chassis setup | en 17
Bosch Sicherheitssysteme GmbH 2016.03 | V1 | DOC
4 Chassis setup
This chapter covers the steps required to install components
and perform maintenance on the chassis.
!
Caution!
Review the warnings and precautions listed in the manual
before setting up or servicing this chassis.
Observe the following prerequisites when adding or replacing
hard disks.
Prerequisites:
– For RAID configuration, all hard disks of the unit must have
the same capacity
Notice!
Insert the hard disks before initial system start.
See also
– Safety, page 4
– Installing a hard drive, page 18
4.1 Removing hard drive trays
The drives are mounted in drive carriers to simplify their
installation and removal from the chassis. These carriers also
help promote proper airflow for the drive bays.
To remove hard drive trays from the chassis:
1. Turn off the system.
2. Press the release button on the drive carrier. This extends
the drive carrier handle.
3. Use the handle to pull the drive carrier with the drive out of
the chassis.