FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en
49
Bosch Security Systems B.V.
User manual
2020-01 | V02 | DOC
TCP metadata input
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select
Off
to deactivate the
function. Enter a valid
Sender IP address
.
Syslog
Server IP address
Enter the appropriate IP address of the server.
Server port (0 = Off)
Enter the number of the server port.
Protocol
Select the appropriate protocol:
UDP
,
TCP
, or
TLS
.
LLDP power config
Requested for camera
The value in this field identifies the number of watts requested for the camera.
Additional Power
Enter the number of additional watts that you want the camera to use.
Requested total
The value in this field is the total number of watts from the fields
Requested for camera
and
Additional Power
.
Allocated power
The value in this field is the number of watts of allocated power to the camera.
Click
Set
to apply the changes.
4.7.5
Network Management
SNMP
The camera supports the SNMP V1 legacy (Simple Network Management Protocol) and SNMP
V3 for managing and monitoring network components, and can send SNMP messages (traps)
to IP addresses. It supports SNMP MIB II in the unified code.
If
On
is selected for the SNMP parameter and a SNMP host address is not entered, the device
does not send the traps automatically and will only reply to SNMP requests. If one or two
SNMP host addresses are entered, SNMP traps are sent automatically. Select
Off
to
deactivate the SNMP function.
SNMP host addresses
To send SNMP traps automatically, enter the IP
address of one or two target devices here.
SNMP traps
To choose which traps are sent:
1.
Click
Select
. A dialog box appears.
2.
Click the check boxes of the appropriate traps.
3.
Click
Set
to close the window and send all of the checked traps.
UPnP
Select
On
to activate UPnP communication. Select
Off
to deactivate it.
When the Universal Plug-and-Play (UPnP) function is activated, the unit responds to requests
from the network and is automatically registered on the requesting computers as a new
network device. This function should not be used in large installations due to the large number
of registration notifications.
