FLEXIDOME IP 3000i IR | FLEXIDOME IP micro
3000i | DINION IP 3000i IR | FLEXIDOME IP turret
3000i IR
Configuration | en
45
Bosch Security Systems B.V.
User manual
2020-01 | V02 | DOC
Action
Select a type of action to be performed when an alarm input occurs:
–
None
–
Monochrome
This switches the camera to the monochrome mode.
Click
Set
to apply the changes.
4.6.2
Alarm Outputs
Configure the switching behavior of the output.
Select different events that automatically activate an output. For example, turn on a floodlight
by triggering a motion alarm and then turn the light off again when the alarm has stopped.
Idle state
Select
Open
for the output to operate as a normally open contact, or select
Closed
if the
output is to operate as a normally closed contact.
Operating mode
Select the way the output works.
For example, if you want an activated alarm to stay on after the alarm ends, select
Bistable
. If
you wish an activated alarm to stay on for ten seconds for example, select
10
s
.
Output follows
Select the event that triggers the output.
Output name
The alarm output can be assigned a name here. This name appears on the Live page.
Toggle
Click the button to switch the alarm output manually (for example, for testing purposes or to
operate a door opener).
Click
Set
to apply the changes.
4.7
Network
The settings on these pages are used to integrate the device into a network. Some changes
only take effect after a reboot. In this case
Set
changes to
Set and Reboot
.
1.
Make the desired changes.
2.
Click
Set and Reboot
.
The device is rebooted and the changed settings are activated.
4.7.1
Network Services
This page shows an overview of all available network services. Use the checkbox to activate or
deactivate a network service. Click on the settings symbol next to the network service to go to
the settings page for this network service.
4.7.2
Network Access
If the IP address, subnet mask, or gateway address is changed, then the device is only
available under the new addresses after the reboot.
Automatic IPv4 assignment
If the network has a DHCP server for the dynamic assignment of IP addresses, select
On
or
On
plus Link-Local
to automatically accept the DHCP-assigned IP address.
If no DHCP server is available select
On plus Link-Local
to automatically assign a Link-Local
(Auto-IP) address.
