DICENTIS
Configuring an IDESK (directly on the device) | en
97
Bosch Security Systems B.V.
Configuration manual
2021.06 | V3.7 |
8
Configuring an IDESK (directly on the device)
To configure the DCNM-IDESK / DCNM-IDESKVID on the device itself, press the B - B buttons
at the same time. The
B - B
buttons (input channel B and output channel B) are located on
both sides of the display and can be easily recognized by the small raised dashes. The
configuration pane opens with these options:
–
Booth No. - Desk No.:
To assign a device to a booth and a desk within that booth. If you
assign a desk to a number that has already been used, the previous booth - desk
combination will be overwritten by the new desk.
Note:
When you connect a new desk to a DICENTIS system, it will not be assigned
automatically, but you have to configure it via the
B - B
buttons on the desk or via the
Meeting application/API. When a desk is connected that was connected before, it will
return to its original booth and desk number.
–
Available languages:
Offers you the possibility to configure the number of languages and
which languages are available. Use
Language selection, page 75 to determine which
languages are available.
–
Output A + B + C:
Select the language for the A output (usually the language the
interpreter interprets to) and the languages for the B and C outputs (from the list of
available languages).
–
Display brightness:
Adjust the brightness of the display by pressing the button (1 - 15)
and using the rotary control. The default value is 7.
–
Auto configure desks:
Automatically configures all interpreter desks in the system. This
means the A output will be set to the language that corresponds to the booth number.
The B and C outputs will be set to none and the 7 pre-select buttons for the input
languages will be configured as 1
st
button - 1
st
language, 2
nd
button - 2
nd
language, and so
on.
–
System information:
Shows system information for the interpreter device and OMNEO
(firmware version, IP address, etc.).
–
Click the Exit button (at the lower right side from your display) to exit each of the above
menu options.
Note:
All changes made in the configuration on the Interpreter desk are directly visible in
the Meeting application (real-time) and may impact the meeting (if there is an active
meeting going on). Therefore, when there is an active meeting, no changes in the
configuration should be made.
Note:
For instructions on how to operate the interpreter desk (for interpreters), please
refer to the Quick reference card that is provided separately for the DCNM-IDESK /
DCNM-IDESKVID.
Refer to
–